LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 143 (Automatic Transmission - A750F) >> Floor Shift Assembly >> Removal

Floor Shift Assembly: Removal

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE TRANSFER SHIFT LEVER KNOB 
  2. REMOVE CONSOLE PANEL SUB-ASSEMBLY UPPER 
    1. Remove the console panel sub-assembly upper (see REMOVAL ).
  3. DISCONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY 
    1. Shift into the N position.
    2. Remove the nut and disconnect the No. 1 floor shift gear shifting rod from the connecting rod swivel.
    Fig 1: Locating Floor Shift Gear Shifting Rod Nut
    G05197144Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE FLOOR SHIFT LEVER ASSEMBLY 
    1. Disconnect the connector.
    2. Remove the 6 bolts.

      Torque: 8.3 N*m (85 kgf*cm, 73 in.*lbf) 

    3. Remove the floor shift lever assembly.
    Fig 2: Locating Floor Shift Lever Assembly Bolts
    G05197145Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals