LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 140 (Supplemental Restraint System) >> Front Passenger Airbag Assembly >> Installation

Front Passenger Airbag Assembly: Installation

WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (see DATA LIST / ACTIVE TEST ).
Fig 1: Removing Front Passenger Airbag
G05184636Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  1. INSTALL FRONT PASSENGER AIRBAG ASSEMBLY 
    1. Attach the rear side hook of the front passenger airbag to the rear side airbag door.
    2. Bend the front side hook so that it attaches to the front side airbag door.
    3. Install the instrument panel upper (See INSTALLATION ).
    4. Install the 2 bolts to the reinforcement.

      Torque: 20 N*m (203 kgf*cm, 14 ft.*lbf) 

    5. Connect the connector to the airbag.
      NOTE: When handling the airbag connector, do not damage the airbag wire harness.
    6. Attach the wire harness clamp to the bracket.
    Fig 2: Connecting Connector To Airbag
    G05184637Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY  (see INSTALLATION )
  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  4. CHECK SRS WARNING LIGHT 
    1. Check the SRS warning light (see PROBLEM SYMPTOMS TABLE ).
scientia non olet · About LEMON Manuals