Center Airbag Sensor Assembly: Installation

WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (see DATA LIST / ACTIVE TEST ).

Fig 1: Identifying Center Airbag Sensor Bolts

INSTALL CENTER AIRBAG SENSOR ASSEMBLY
1. Install the airbag sensor with the 3 bolts.
  Torque: 17.5 N*m (179 kgf*cm, 13 ft.*lbf)
  NOTE:
  - If the airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
  - When installing the airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
2. Connect the airbag sensor connectors.
Fig 2: Identifying Center Airbag Sensor Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR CONSOLE BOX ASSEMBLY (see INSTALLATION )
INSTALL NO. 1 INSTRUMENT PANEL BRACKET COVER INNER LH (see INSTALLATION )
INSTALL NO. 1 INSTRUMENT PANEL BRACKET COVER INNER RH (see INSTALLATION )
INSTALL CONSOLE REAR END PANEL (see INSTALLATION )
INSTALL UPPER REAR CONSOLE PANEL SUB-ASSEMBLY (see INSTALLATION )
INSTALL CONSOLE CUP HOLDER BOX (see INSTALLATION )
INSTALL SWITCH BASE (see INSTALLATION )
INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (see INSTALLATION )
INSTALL NO. 2 CONSOLE UPPER PANEL GARNISH (see INSTALLATION )
INSTALL NO. 1 CONSOLE UPPER PANEL GARNISH (see INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
CHECK SRS WARNING LIGHT
1. Check the SRS warning light (see PROBLEM SYMPTOMS TABLE ).