LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Parking Brake >> Parking Brake Lever >> On-Vehicle Inspection

On-Vehicle Inspection

  1. REMOVE REAR WHEEL 
  2. ADJUST PARKING BRAKE SHOE CLEARANCE  (See INSTALLATION  )
  3. INSTALL REAR WHEEL 

    Torque: 112 N*m (1,137 kgf*cm, 82 ft.*lbf) 

  4. INSPECT PARKING BRAKE LEVER TRAVEL 
    1. Slowly pull the parking brake lever to the fully applied position, counting the number of clicks.

      Parking brake lever travel: 5 to 7 clicks at 200 N (20 kgf, 45 lbf) 

  5. REMOVE PARKING BRAKE HOLE COVER SUB-ASSEMBLY  (See REMOVAL )
  6. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission)  (See REMOVAL )
  7. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for 4WD)  (See REMOVAL )
  8. REMOVE CONSOLE UPPER REAR PANEL SUB-ASSEMBLY  (See REMOVAL )
  9. ADJUST PARKING BRAKE LEVER TRAVEL 
    1. Turn the adjusting nut until the parking brake lever travel is corrected to within the specified range.

      Parking brake lever travel: 5 to 7 clicks at 200 N (20 kgf, 45 lbf) 

    2. Operate the parking brake lever 3 to 4 times, and check the parking brake lever travel.
    3. Check whether the parking brake drags or not.
    4. When operating the parking brake lever, check that the brake warning light illuminates.

      Standard: Brake warning light always illuminates at the first click. 

      Fig 1: Identifying Parking Brake Lever Travel
      G05112514Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  10. INSTALL CONSOLE UPPER REAR PANEL SUB-ASSEMBLY  (See INSTALLATION )
  11. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for 4WD)  (See INSTALLATION )
  12. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission)  (See INSTALLATION )
  13. INSTALL PARKING BRAKE HOLE COVER SUB-ASSEMBLY  (See INSTALLATION )
scientia non olet · About LEMON Manuals