Fender Panel Mudguard: Removal

HINT:

The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Back Sonar) 
2. REMOVE REAR BUMPER COVER  (See REMOVAL  )
3. REMOVE FRONT FENDER MUDGUARD 
   1. Using a clip remover, remove the clip.
   2. Remove the 5 screws and the front fender mudguard.
      Fig 1: Identifying Front Fender Mudguard Screws

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. REMOVE QUARTER PANEL MUDGUARD 
   1. Using a clip remover, remove the clip.
   2. Remove the 4 screws and the quarter panel mudguard.
      Fig 2: Identifying Quarter Panel Mudguard Screws

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002