Rear Bumper: Removal

1. Apply protective tape.
   Fig 1: Identifying Protective Tape

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the 7 bolts and the 2 screws.
   Fig 2: Identifying Rear Bumper Bolts & Screws

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. w/ Back Sonar:
   1. Disconnect the 2 wire to wire connectors.
      Fig 3: Identifying Wire Connectors

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Disengage the 6 claws and the 2 clips and remove the rear bumper cover.
   Fig 4: Identifying Rear Bumper Cover Claws & Clips

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the screw.
2. Disengage the 2 claws and remove the rear bumper end retainer.
Fig 5: Identifying Rear Bumper End Retainer Claws
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

Use the same procedure as for the LH side.

1. Remove the 2 screws.
2. Disengage the 3 claws and remove the rear bumper upper retainer.
Fig 6: Identifying Rear Bumper Upper Retainer Claws
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

Use the same procedure as for the LH side.

1. Disengage the 2 claws and remove the rear bumper energy absorber.
   Fig 7: Identifying Rear Bumper Energy Absorber Claws

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the bolt and the rear bumper side stay.
   Fig 8: Identifying Rear Bumper Side Stay Bolt

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

Use the same procedure as for the LH side.

1. Remove the 2 bolts and the rear bumper side support.
   Fig 9: Identifying Rear Bumper Side Support Sub-Assembly Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

Use the same procedure as for the LH side.

1. Remove the bolt and the rear bumper bar bracket.
   Fig 10: Identifying Rear Bumper Bar Bracket Bolt

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

Use the same procedure as for the LH side.