Fender Panel Mudguard: Installation

HINT:

The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.

1. INSTALL QUARTER PANEL MUDGUARD 
   1. Align the 2 pins of the quarter panel mudguard with the installation hole of the quarter outside molding.
   2. Install the quarter panel mudguard with the 4 screws.

      Torque: 5.0 N*m (50 kgf*cm, 44 in.*lbf) 

   3. Install the clip.
      Fig 1: Identifying Quarter Panel Mudguard Screws And Clip

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. INSTALL FRONT FENDER MUDGUARD 
   1. Align the pin of the front fender mudguard with the installation hole of the front fender molding.
   2. Install the front fender mudguard with the 5 screws.

      Torque: 5.0 N*m (50 kgf*cm, 44 in.*lbf) 

   3. Install the clip.
      Fig 2: Identifying Front Fender Mudguard Screws & Clip

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. INSTALL REAR BUMPER COVER  (See INSTALLATION  )
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Back Sonar) 

   Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)