Front Door Speaker: Installation

HINT:

The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.

1. INSTALL FRONT NO. 1 SPEAKER ASSEMBLY 
   1. Install the front No. 1 speaker with the 4 screws.

      Torque: 2.5 N*m (25 kgf*cm, 22 in.*lbf) 

      Fig 1: Identifying Front No. 1 Speaker Screws

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Connect the speaker connector.
   Fig 2: Identifying Front No. 1 Speaker Connector

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. INSTALL FRONT DOOR TRIM BOARD SUBASSEMBLY  (See REASSEMBLY )
3. INSTALL FRONT DOOR ARMREST BASE UPPER PANEL  (See REASSEMBLY )
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 

   Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)