Transmission Control Cable Assembly: Installation

INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY
1. Install the retainer to the shift cable.
2. Pull in the control cable assembly to the body.
3. Install the 2 bolts.
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
  
  Fig 1: Identifying Control Cable Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Install the control cable to the shift lever plate.
  
  Fig 2: Identifying Shift Lever Plate
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Connect the control cable end to the floor shift assembly.
  HINT:
  
  Install it with the uneven surface facing up.
  
  Fig 3: Identifying Control Cable End
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Install the control cable with the 2 nuts to the body.
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
  
  Fig 4: Identifying Control Cable Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
7. Connect the control cable to the control cable support.
8. Temporarily install the control cable to the control shaft lever with nut.
9. Install the control cable with the clip to the bracket.
  NOTE: Insert the cable securely.
  
  Fig 6: Identifying Clip And Control Cable
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL AIR CLEANER ASSEMBLY WITH HOSE
Torque: 7.0 N*m (71 kgf*cm, 62 in.*lbf)
INSTALL NO.1 FRONT FLOOR HEAT INSULATOR
1. Install the heat insulator with the 3 nuts.
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
INSTALL FRONT EXHAUST PIPE ASSEMBLY
INSTALL FRONT FLOOR PANEL BRACE
1. Install the floor panel brace with the 2 nuts.
  Torque: 30 N*m (306 kgf*cm, 22 ft.*lbf)
INSTALL OXYGEN SENSOR CONNECTOR
1. Connect the oxygen sensor connector.
2. Install the floor carpet and foot rest.
INSTALL CENTER AIRBAG SENSOR ASSEMBLY SST 09249-63010
ADJUST SHIFT LEVER POSITION (See ADJUSTMENT )
INSPECT SHIFT LEVER POSITION (See ADJUSTMENT )
INSPECT SRS WARNING LIGHT
HINT:

(See DATA LIST / ACTIVE TEST )