LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Corolla CE, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Clutches Manual & Hydraulic) >> Clutch Start Switch >> Installation

Clutch Start Switch: Installation

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL CLUTCH START SWITCH ASSEMBLY 
    1. Install the clutch start switch assembly with the nut.

      Torque: 16 N*m (160 kgf*cm, 12 ft.*lbf) 

    2. Connect the clutch start switch assembly connector.
  2. INSPECT CLUTCH START SWITCH ASSEMBLY  (see ON-VEHICLE INSPECTION )
scientia non olet · About LEMON Manuals