TIRE PRESSURE WARNING RECEIVER (w/ Antenna): Removal
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
- REMOVE REAR SEAT CUSHION ASSEMBLY (for Fixed Seat Type)
(See REMOVAL
)
- REMOVE REAR SEAT HEADREST ASSEMBLY (for Fixed Seat Type)
- REMOVE REAR CENTER SEAT HEADREST ASSEMBLY (for Fixed Seat Type)
- REMOVE REAR SEATBACK ASSEMBLY (for Fixed Seat Type)
(See REMOVAL
)
- REMOVE REAR SEAT CUSHION ASSEMBLY (for Fold Down Seat Type)
(See REMOVAL
)
- REMOVE REAR SIDE SEATBACK ASSEMBLY LH (for Fold Down Seat Type)
(See REMOVAL
)
- REMOVE REAR SEAT HEADREST ASSEMBLY (for Reclining Seat Type)
- REMOVE REAR SEAT CUSHION ASSEMBLY (for Reclining Seat Type)
(See REMOVAL
)
- REMOVE REAR SEATBACK COVER (for Reclining Seat Type)
(See REMOVAL
)
- REMOVE SEPARATE TYPE REAR SEATBACK ASSEMBLY LH (for Reclining Seat Type)
(See REMOVAL
)
- REMOVE INNER ROOF SIDE GARNISH LH
(See REMOVAL
)
- REMOVE TIRE PRESSURE WARNING RECEIVER ASSEMBLY
- Remove the bolt.
- Disconnect the connector and remove the tire pressure warning receiver assembly.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002