LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Camry Base, Automatic >> Repair and Diagnosis >> Suspension >> Wheels & Tire System >> Tire & Wheel (Except Hybrid) >> TIRE PRESSURE WARNING RECEIVER (w/ Antenna) >> Installation

TIRE PRESSURE WARNING RECEIVER (w/ Antenna): Installation

  1. INSTALL TIRE PRESSURE WARNING RECEIVER ASSEMBLY 
    1. Connect the connector to the tire pressure warning receiver assembly.
    2. Install the tire pressure warning receiver assembly with the bolt

      Torque: 7.5 N*m (77 kgf*cm, 66 in.*lbf) 

      Fig 1: Locating Tire Pressure Warning Receiver Assembly Connector
      G04977871Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL INNER ROOF SIDE GARNISH LH  (See INSTALLATION )
  3. INSTALL REAR SEATBACK ASSEMBLY (for Fixed Seat Type)  (See INSTALLATION )
  4. INSTALL REAR CENTER SEAT HEADREST ASSEMBLY (for Fixed Seat Type) 
  5. INSTALL REAR SEAT HEADREST ASSEMBLY (for Fixed Seat Type) 
  6. INSTALL REAR SEAT CUSHION ASSEMBLY (for Fixed Seat Type)  (See INSTALLATION )
  7. INSTALL REAR SIDE SEATBACK ASSEMBLY LH (for Fold Down Seat Type)  (See INSTALLATION )
  8. INSTALL REAR SEAT CUSHION ASSEMBLY (for Fold Down Seat Type)  (See INSTALLATION )
  9. INSTALL REAR SEATBACK ASSEMBLY LH (for Reclining Seat Type)  (See INSTALLATION )
  10. INSTALL REAR SEATBACK COVER (for Reclining Seat Type) 
  11. INSTALL REAR SEAT HEADREST ASSEMBLY (for Reclining Seat Type) 
  12. INSTALL BENCH TYPE REAR SEAT CUSHION ASSEMBLY (for Reclining Seat Type)  (See INSTALLATION )
  13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  14. INSPECT TIRE PRESSURE WARNING SYSTEM 

    HINT:

    (See TEST MODE PROCEDURE  )

scientia non olet · About LEMON Manuals