Heated Oxygen Sensor: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL HEATED OXYGEN SENSOR (for Bank 2)
1. Using SST, install the heated oxygen sensor.
  SST 09224-00010
  
  Torque: 44 N*m (449 kgf*cm, 32 ft.*lbf)
  
  Fig 1: Identifying Heated Oxygen Sensor (For Bank 2)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL HEATED OXYGEN SENSOR (for Bank 1)
1. Using SST, install the heated oxygen sensor.
  SST 09224-00010
  
  Fig 2: Identifying Heated Oxygen Sensor (For Bank 1)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT EXHAUST PIPE ASSEMBLY (See INSTALLATION )
INSTALL ENGINE UNDER COVER LH
INSTALL ENGINE UNDER COVER RH