Section 67 (Engine Control System (2GR-FE Except Hybrid) - System And Circuit Testing, On-Vehicle Inspection, Removal, Inspection And Installation): ECM: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL ECM
1. Install the ECM bracket with the 4 screws.
  Torque: 3.0 N*m (31 kgf*cm, 27 in.*lbf)
2. Connect the 2 ECM connectors.
  NOTE: When connecting the connector, make sure that dirt, water and other foreign matter do not become stuck between the connector and other parts.
  
  Fig 1: Locating ECM Brackets Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  1. Connect the 2 ECM connectors and lower the 2 levers.
    NOTE: Make sure that the 2 levers are securely lowered.
    
    Fig 2: Connecting ECM Connectors And Levers
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the ECM with the 3 nuts.
  Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
  
  Fig 3: Locating ECM Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL COWL TOP PANEL OUTER SUB-ASSEMBLY (See INSTALLATION )
INSTALL WINDSHIELD WIPER MOTOR AND LINK (See INSTALLATION )
INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY (See INSTALLATION )
INSTALL FRONT FENDER TO COWL SIDE SEAL RH (See INSTALLATION )
INSTALL FRONT FENDER TO COWL SIDE SEAL LH (See INSTALLATION )
INSTALL WINDSHIELD WIPER ARM AND BLADE ASSEMBLY LH (See INSTALLATION )
INSTALL WINDSHIELD WIPER ARM AND BLADE ASSEMBLY RH (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (See INSTALLATION )