Differential Oil Seal: Removal

WARNING: This page is about a different variant/trim than selected.

HINT:

Use the same procedures for the RH side (transaxle case oil seal) and LH side (transaxle case cover oil seal).
The procedures listed below are for the LH side (transaxle case cover oil seal).

DRAIN MANUAL TRANSAXLE OIL
1. Remove the filler plug and the gasket.
2. Remove the drain plug and gasket, and drain the manual transaxle oil.
3. Install a new gasket and the drain plug.
Torque: 49 N*m (500 kgf*cm, 36 ft.*lbf)
REMOVE FRONT WHEELS
REMOVE FRONT DRIVE SHAFT ASSEMBLY LH
TMC made: (See REMOVAL ).

TMMK made: (See REMOVAL ).
REMOVE FRONT DRIVE SHAFT ASSEMBLY RH
HINT:

Use the same procedures described for the LH side.
REMOVE FRONT TRANSAXLE CASE COVER OIL SEAL
1. Using SST, remove the oil seal.
  SST 09308-00010
  
  Fig 1: Removing Front Transaxle Case Cover Oil Seal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE TRANSAXLE CASE OIL SEAL
1. Using SST, remove the oil seal.
  SST 09308-00010
  
  Fig 2: Removing Transmission Case Oil Seal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002