FRONT DRIVE SHAFT (for TMMK Made): Removal

HINT:

• Use the same procedures for the RH side and LH side.
• The procedures listed below are for the LH side.

1. DRAIN AUTOMATIC TRANSAXLE FLUID (for Automatic Transaxle) 
   1. for 2GR-FE: See REMOVAL
   2. for 2AZ-FE: See REMOVAL
2. DRAIN MANUAL TRANSAXLE OIL (for Manual Transaxle)  (See REMOVAL )
3. REMOVE FRONT WHEEL 
4. REMOVE FRONT AXLE HUB NUT  (See REMOVAL )
5. SEPARATE FRONT STABILIZER LINK ASSEMBLY  (See REMOVAL )
6. SEPARATE FRONT SPEED SENSOR  (See REMOVAL )
7. SEPARATE TIE ROD END SUB-ASSEMBLY  (See REMOVAL )
8. SEPARATE FRONT SUSPENSION LOWER NO. 1 ARM  (See REMOVAL )
9. SEPARATE FRONT AXLE ASSEMBLY  (See REMOVAL )
10. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH  (See REMOVAL )
11. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH  (See REMOVAL )
12. SECURE FRONT AXLE HUB SUB-ASSEMBLY  (See REMOVAL )
13. INSPECT FRONT DRIVE SHAFT ASSEMBLY  (See INSPECTION )