Clutch Accumulator: Removal

WARNING: This page is about a different variant/trim than selected.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE AIR CLEANER INLET ASSEMBLY (See REMOVAL )
REMOVE AIR CLEANER CAP SUB-ASSEMBLY (See REMOVAL )
REMOVE AIR CLEANER CASE SUB-ASSEMBLY (See REMOVAL )
REMOVE CLUTCH ACCUMULATOR BRACKET
1. Remove the 2 bolts and clutch accumulator bracket.
  
  Fig 1: Removing Clutch Accumulator Bracket Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE RELEASE CYLINDER HEAT INSULATOR
1. Remove the 2 bolts and release cylinder heat insulator.
Fig 2: Locating Cylinder Heat Insulator Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
DISCONNECT CLUTCH LINE
1. Using SST, disconnect the clutch lines.
  SST 09023-00101
  
  HINT:
  
  Use a container to catch the fluid.
  
  Fig 3: Disconnecting Clutch Lines Using SST
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE CLUTCH ACCUMULATOR ASSEMBLY
1. Remove the 2 nuts and clutch accumulator assembly.
  
  Fig 4: Removing Clutch Accumulator Assembly Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002