LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Camry Base, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Exhaust Assembly (2GR-FE)) >> Exhaust Pipe And Catalytic Converter >> Removal

Exhaust Pipe And Catalytic Converter: Removal

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE EXHAUST TAIL PIPE ASSEMBLY 
    1. Remove the 4 nuts and 2 exhaust tail pipes.
    2. Remove the 2 gaskets from the exhaust center pipe assembly.
    Fig 1: Locating Exhaust Tail Pipes Nuts
    G04975223Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. REMOVE EXHAUST CENTER PIPE ASSEMBLY 
    1. Remove the 2 bolts, 2 nuts and exhaust center pipe assembly.
    2. Remove the gasket from the exhaust pipe assembly.
    Fig 2: Locating Exhaust Center Pipe Assembly Bolts And Nuts
    G04975224Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE FRONT EXHAUST PIPE NO. 1 SUPPORT BRACKET 
    1. Remove the 2 nuts and front support brackets.
    Fig 3: Locating Front Support Brackets Nuts
    G04975225Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE EXHAUST FRONT PIPE ASSEMBLY 
    1. Disconnect the 2 heated oxygen sensor (bank 1, 2 sensor 2) connectors.
    2. Remove the 2 nuts from the exhaust front pipe (left bank exhaust manifold side).
    3. Remove the 2 nuts from the exhaust front pipe (right bank exhaust pipe manifold side).
    4. Remove the exhaust front pipe.
    5. Remove the 2 gaskets from the exhaust front pipe.
    Fig 4: Locating Exhaust Front Pipe Assembly
    G04975226Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE HEATED OXYGEN SENSOR  (See REMOVAL )
  6. REMOVE REAR EXHAUST PIPE NO. 1 SUPPORT BRACKET 
    1. Remove the 2 bolts and rear support bracket.
    Fig 5: Locating Rear Support Bracket Bolts
    G04975217Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals