LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Camry Base, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Starting System (2GR-FE)) >> Starter >> Removal

Section 10 (Starting System (2GR-FE)): Starter: Removal

WARNING: This page is about a different variant/trim than selected.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  2. REMOVE COOL AIR INTAKE DUCT SEAL  (See REMOVAL )
  3. REMOVE V-BANK COVER SUB-ASSEMBLY  (See REMOVAL )
  4. REMOVE AIR CLEANER INLET ASSEMBLY  (See REMOVAL )
  5. REMOVE AIR CLEANER CAP SUB-ASSEMBLY  (See REMOVAL )
  6. REMOVE AIR CLEANER CASE SUB-ASSEMBLY  (See REMOVAL )
  7. REMOVE NO. 1 AIR CLEANER INLET  (See REMOVAL )
  8. REMOVE STARTER ASSEMBLY 
    1. Disconnect the terminal 50 connector from the starter assembly.
      Fig 1: Locating Bolts And Starter Assembly
      G04975667Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the nut and disconnect the wire harness from terminal 30.
    3. Remove the 2 bolts and starter assembly.
scientia non olet · About LEMON Manuals