LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Camry Base, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical (2GR-FE)) >> Drive Belt >> Removal

Drive Belt: Removal

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE FRONT WHEEL RH 
  2. REMOVE FRONT FENDER APRON SEAL RH 
  3. REMOVE V-BANK COVER SUB-ASSEMBLY  (See REMOVAL )
  4. REMOVE V-RIBBED BELT 
    1. Using SST, release the belt tension by turning the belt tensioner counterclockwise, and remove the V-ribbed belt from the belt tensioner.

      SST 09249-63010 

      Fig 1: Turning Belt Tensioner Counterclockwise
      G04974417Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. While turning the belt tensioner counterclockwise, align with its holes, and then insert the 5 mm bi-hexagon wrench into the holes to fix the V-ribbed belt tensioner.
      Fig 2: Inserting Bi-Hexagon Wrench Into Holes To Fix V-Ribbed Belt Tensioner
      G04974418Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals