LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Camry Base, Automatic >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> Engine Control System (2AZ-FE) (Except Hybrid) >> Camshaft Timing Oil Control Valve Assembly >> Removal

Camshaft Timing Oil Control Valve Assembly: Removal

  1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY  (See REMOVAL )
  2. REMOVE VACUUM HOSE CLAMP 
    1. Remove the bolt and disconnect the vacuum hose damp.
      Fig 1: Locating Vacuum Hose Clamp Bolt
      G04973346Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE CLIP NUT 
    1. Remove the clip nut.
      Fig 2: Locating Clip Nut
      G04973347Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY 
    1. Disconnect the camshaft timing oil control valve assembly connector.
    2. Remove the bolt and camshaft timing oil control valve assembly.
      Fig 3: Locating Camshaft Timing Oil Control Valve Assembly Connector
      G04973348Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals