Fuel Injector: Removal

HINT:

See PRECAUTION .

1. Remove the No. 1 fuel pipe clamp.
   NOTE: Check for foreign matter on the pipe and around the connector before disconnecting the quick connector. Clean the connector if necessary.
   Fig 1: Identifying No. 1 Fuel Pipe Clamp

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. If the connector and pipe are stuck, pinch the connector, and push and pull the pipe to disconnect them.
   Fig 2: Disconnecting Connector

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   NOTE:

   • Do not use any tools in this procedure.
   • Check for foreign matter on the sealing surface of the disconnected pipe. Clean it if necessary.
3. Separate the fuel tube from the fuel hose clamp.
   Fig 3: Identifying Fuel Hose Clamp

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Disconnect the No. 2 ventilation hose from the ventilation valve.
   Fig 4: Identifying No. 2 Ventilation Hose

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the 2 wire harness clamps.
2. Disconnect the 4 fuel injector connectors.
   Fig 5: Identifying Fuel Injector Connectors

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Remove the 2 bolts, then remove the fuel delivery pipe together with the 4 fuel injectors.
   NOTE: Be careful not to drop the fuel injectors when removing the fuel delivery pipe.
   Fig 6: Identifying Fuel Delivery Pipe Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Remove the 2 delivery pipe spacers from the cylinder head.
5. Remove the 4 insulators from the cylinder head.
   Fig 7: Locating Insulators And Delivery Pipe Spacers From Cylinder Head

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Pull out the 4 injectors from the delivery pipe.
2. Remove the 4 O-rings from the injectors.
   Fig 8: Pulling Out Injectors From Delivery Pipe

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002