Engine Front Oil Seal: Removal

REMOVE FRONT WHEEL RH
REMOVE FRONT FENDER APRON SEAL RH
REMOVE ENGINE UNDER COVER LH
REMOVE ENGINE UNDER COVER RH
REMOVE V-RIBBED BELT (See REMOVAL )
REMOVE CRANKSHAFT PULLEY
1. TMMK made:
  1. Using SST, fix the pulley in place and loosen the pulley bolt.
    SST 09960-10010 (09962-01000, 09963-01000)
    
    Fig 1: Fixing Pulley And Loosening Bolt
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. Using SST, remove the pulley bolt and pulley.
    SST 09950-40011 (09951-04010,09952-04010, 09953-04030, 09955-04041, 09957-04010, 09954-04010, 91111-51014)
    
    Fig 2: Removing Pulley Bolt And Pulley
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. TMC made:
  1. Using SST, fix the pulley in place and loosen the pulley bolt.
    SST 09213-54015 (91651-60855), 09330-00021
    
    Fig 3: Loosening Pulley Bolt
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. Using SST, remove the pulley bolt and pulley.
    SST 09950-50013 (09951 -05010, 09952-05010, 09953-05020, 09954-05021), 09950-40011 (09957-04010)
    
    HINT:
    
    If necessary, remove the pulley and pulley bolt using SST.
    
    Fig 4: Removing Pulley And Pulley Bolt
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE TIMING CHAIN CASE OIL SEAL
1. Using a knife, cut off the oil seal lip.
2. Using a screwdriver with the tip taped, pry out the oil seal.
  NOTE: After the removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.
  
  Fig 5: Prying Out Oil Seal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002