Rear Axle Hub And Bearing: Removal

HINT:

• Use the same procedures for the RH side and LH side.
• The procedures listed below are for the LH side.

1. REMOVE REAR WHEEL 
2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY  (See REMOVAL )
3. REMOVE REAR DISC  (See DISASSEMBLY )
4. DISCONNECT SKID CONTROL SENSOR CONNECTOR  (See REMOVAL )
5. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY 
   1. Disconnect the skid control sensor connector.
   2. Remove the 4 bolts and hub and bearing assembly.
      Fig 1: Locating Bearing Assembly Hub Bolts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002