LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Camry Base, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> Lighting (Except Hybrid) >> Headlight Assembly >> Installation

Headlight Assembly: Installation

  1. INSTALL HEADLIGHT ASSEMBLY 
    1. Connect the connectors.
    2. Install the headlight assembly with the bolt and 2 screws.

      Torque: 3.6 N*m (37 kgf*cm, 32 in.*lbf) 

    Fig 1: Identifying Headlight Assembly
    G04980118Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL FRONT BUMPER ASSEMBLY (w/o Fog Light)  (See INSTALLATION )
  3. INSTALL FRONT BUMPER ASSEMBLY (w/ Fog Light)  (See INSTALLATION )
  4. INSTALL COOL AIR INTAKE DUCT SEAL (for 2GR-FE)  (See INSTALLATION )
  5. VEHICLE PREPARATION FOR HEADLIGHT AIM ADJUSTMENT (See  ADJUSTMENT   ) 
  6. PREPARATION FOR HEADLIGHT AIMING (Using a tester) (See  ADJUSTMENT   ) 
  7. PREPARATION FOR HEADLIGHT AIMING (Using a screen) (See  ADJUSTMENT   ) 
  8. HEADLIGHT AIMING INSPECTION (See  ADJUSTMENT   ) 
  9. HEADLIGHT AIMING ADJUSTMENT (See  ADJUSTMENT   ) 
  10. VEHICLE PREPARATION FOR FOG LIGHT AIM ADJUSTMENT (w/ Fog Light) (See  ADJUSTMENT   ) 
  11. PREPARATION FOR FOG LIGHT AIMING (w/ Fog Light) (See  ADJUSTMENT   ) 
  12. FOG LIGHT AIMING INSPECTION (w/ Fog Light) (See  ADJUSTMENT   ) 
  13. FOG LIGHT AIMING ADJUSTMENT (w/ Fog Light) (See  ADJUSTMENT   ) 
scientia non olet · About LEMON Manuals