Front Bumper: Installation

INSTALL FRONT BUMPER ASSEMBLY (w/o Fog Light)
1. Engage each claw.
2. Install the front bumper assembly with the 8 screws, 2 clips, 2 radiator grille protectors and bolt.
  
  Fig 1: Identifying Radiator Grille Protectors Screws And Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the pin hold clip.
  
  Fig 2: Installing Pin Hold Clip
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  HINT:
  
  Use the same procedures for the RH side and LH side.
INSTALL FRONT BUMPER ASSEMBLY (w/ Fog Light)
1. Connect each connector.
2. Engage each claw.
3. Install the front bumper assembly with the 8 screws, 2 clips, 2 radiator grille protectors and bolt.
  
  Fig 3: Identifying Radiator Grille Protectors Screws And Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Install the pin hold clip.
  
  Fig 4: Installing Pin Hold Clip
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  HINT:
  
  Use the same procedures for the RH side and LH side.
INSTALL COOL AIR INTAKE DUCT SEAL (for 2GR-FE)
1. Install the cool air intake duct seal with the 7 clips.
  
  Fig 5: Identifying Cool Air Intake Duct Seal Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
VEHICLE PREPARATION FOR FOG LIGHT AIMING (w/ Fog Light) (See ADJUSTMENT )
PREPARATION FOR FOG LIGHT AIMING (w/ Fog Light) (See ADJUSTMENT )
INSPECT FOG LIGHT AIMING (w/ Fog Light) (See ADJUSTMENT )
ADJUST FOG LIGHT AIMING (w/ Fog Light) (See ADJUSTMENT )