LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Avalon XLS >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brakes - Mechanical >> Brake Pedal >> Removal

Brake Pedal: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working.
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
  2. REMOVE WINDSHIELD WIPER ARM AND BLADE ASSEMBLY LH  (See REMOVAL )
  3. REMOVE WINDSHIELD WIPER ARM AND BLADE ASSEMBLY RH  (See REMOVAL )
  4. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY  (See REMOVAL )
  5. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY  (See REMOVAL )
  6. REMOVE COWL TOP PANEL OUTER  (See REMOVAL  )
  7. DRAIN BRAKE FLUID 
  8. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE  (See REMOVAL )
  9. REMOVE AIR CLEANER CASE  (See REMOVAL )
  10. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY  (See REMOVAL  )
  11. DISCONNECT VACUUM HOSE  (See REMOVAL  )
  12. REMOVE FRONT DOOR SCUFF PLATE LH  (See REMOVAL )
  13. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH  (See REMOVAL )
  14. REMOVE INSTRUMENT SIDE PANEL LH  (See REMOVAL )
  15. REMOVE INSTRUMENT PANEL FINISH LOWER PANEL LH  (See REMOVAL )
  16. REMOVE INSTRUMENT PANEL AIR BAG ASSEMBLY LOWER NO. 1  (See REMOVAL )
  17. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH NO. 1  (See REMOVAL )
  18. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH NO. 2  (See REMOVAL )
  19. REMOVE INSTRUMENT PANEL FINISH PLATE (w/o Smart Key System)  (See REMOVAL )
  20. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY  (See REMOVAL )
  21. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY CENTER  (See REMOVAL )
  22. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY  (See REMOVAL )
  23. REMOVE COMBINATION METER ASSEMBLY  (See REMOVAL )
  24. REMOVE BRAKE PEDAL RETURN SPRING  (See REMOVAL  )
  25. REMOVE PUSH ROD PIN  (See REMOVAL  )
  26. REMOVE BRAKE BOOSTER ASSEMBLY  (See REMOVAL  )
  27. REMOVE BRAKE BOOSTER GASKET  (See REMOVAL  )
  28. REMOVE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY 
  29. REMOVE BRAKE PEDAL SUPPORT SUB-ASSEMBLY 
    1. Disconnect the stop light switch connector and wire harness clamp.
      Fig 1: Identifying Wire Harness Clamp
      G05408073Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 bolts and brake pedal support sub-assembly.
      Fig 2: Identifying Bolts And Brake Pedal Support Sub-Assembly
      G05001661Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals