LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2007 >> Highlander Hybrid Limited, AWD >> Repair and Diagnosis >> Suspension >> Front Suspension >> Suspension (Hybrid) >> REAR NO. 1 SUSPENSION ARM (for 2WD) >> Removal

REAR NO. 1 SUSPENSION ARM (for 2WD): Removal

  1. REMOVE REAR WHEEL 
  2. REMOVE REAR STABILIZER LINK ASSEMBLY LH (See  REMOVAL   ) 
  3. REMOVE REAR STABILIZER LINK ASSEMBLY RH (See  REMOVAL   ) 
  4. REMOVE REAR STABILIZER BAR (See  REMOVAL   ) 
  5. REMOVE REAR STABILIZER BAR BRACKET (See  REMOVAL   ) 
  6. REMOVE REAR STABILIZER BUSHING (See  REMOVAL   ) 
  7. REMOVE REAR SUSPENSION NO. 1 ARM 
    1. Remove the bolt and disconnect the rear suspension arm No. 1 (inner side).
      Fig 1: Locating Rear Suspension Arm No. 1 (Inner Side)
      G05202576Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt, nut and the rear suspension arm No. 1 (outer side) from the rear axle carrier.
      Fig 2: Locating Bolt, Nut And Rear Suspension Arm No. 1 (Outer Side)
      G05202577Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE: When removing the bolt, keep the nut from rotating.
scientia non olet · About LEMON Manuals