Front Seat Outer Belt Assembly With PRETENSIONER: Installation

1. Check the degree of tilt when the ELR begins to lock.
   1. Check that the belt does not lock at less than 15 degrees of tilt in any direction but locks at over 45 degrees of tilt when gently moving the installed retractor.
      NOTE: Do not disassemble the retractor.
      Fig 1: Checking Degree Of Tilt When ELR Begins To Lock

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Temporarily install the front seat outer belt assembly with the 2 bolts.
3. Fully tighten the upper bolt first, then the lower bolt to install the front seat outer belt assembly.

   Torque: For upper bolt 

   7.5 N*m (77 kgf*cm, 66 in.*lbf) 

   For lower bolt 

   42 N*m (428 kgf*cm, 31 ft.*lbf) 

   Fig 2: Installing Front Seat Outer Belt Assembly

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect the tension reducer connector.
5. Connect the pretensioner connector and lock the locking tab.
   NOTE: Securely lock the locking tab.
6. Install the shoulder anchor of the front seat outer belt assembly with the bolt.

   Torque: 42 N*m (428 kgf*cm, 31 ft.*lbf) 

7. Install the floor end of the front seat outer belt assembly with the bolt.

   Torque: 42 N*m (428 kgf*cm, 31 ft.*lbf) 

   Fig 3: Connecting Pretensioner Connector

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
8. Check if the ELR locks.
   NOTE: The check should be performed with the outer belt assembly installed.
   1. With the belt assembly installed, check that the belt locks when it is pulled out quickly.

w/o Rear No.2 seat (See INSTALLATION )

w/ Rear No.2 seat (See INSTALLATION )

w/o Rear No.2 seat (See INSTALLATION )

w/ Rear No.2 seat (See INSTALLATION )

w/o Rear No.2 seat (See INSTALLATION )

w/ Rear No.2 seat (See INSTALLATION )

Some systems need initialization when disconnecting the cable from the negative battery cable (See INITIALIZATION ).

(See DIAGNOSIS SYSTEM )