LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2007 >> Highlander Hybrid Limited, AWD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System (Hybrid) >> Spiral Cable >> Installation

Spiral Cable: Installation

  1. INSTALL STEERING ANGLE SENSOR  (See INSPECTION )
  2. INSTALL SPIRAL CABLE 
    1. Check that the front wheels are facing straight ahead.
      Fig 1: Identifying Spiral Cable Claws
      G05242789Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Set the turn signal switch to the neutral position.
      NOTE: If it is not in the neutral position, the pin of the turn signal switch may snap.
    3. Install the spiral cable.
      NOTE: When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel assembly.
    4. Connect the connectors to the spiral cable.
      NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
  3. INSTALL STEERING COLUMN COVER UPPER  (See INSTALLATION )
  4. INSTALL STEERING COLUMN COVER LOWER  (See INSTALLATION )
  5. ADJUST SPIRAL CABLE 
    1. Check that the ignition switch is off.
    2. Check that the battery negative (-) terminal is disconnected.
      CAUTION: After removing the terminal, wait for at least 90 seconds before starting the operation.
    3. Rotate the spiral cable counterclockwise slowly by hand until it feels firm.
      NOTE: Do not turn the spiral cable by the airbag wire harness.
      Fig 2: Rotating Spiral Cable Counterclockwise
      G05242791Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.
      Fig 3: Rotating Spiral Cable Clockwise
      G05203917Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE: Do not turn the spiral cable by the airbag wire harness.

      HINT:

      The spiral cable will rotate approximately 2.5 turns to both the left and right from the center.

  6. INSTALL STEERING WHEEL ASSEMBLY  (See INSTALLATION )
  7. INSPECT STEERING WHEEL CENTER POINT 
  8. INSTALL STEERING PAD (See  REMOVAL   ) 
  9. INSTALL STEERING WHEEL NO.2 COVER LOWER (See  INSTALLATION   ) 
  10. INSTALL STEERING WHEEL NO.3 COVER LOWER (See  INSTALLATION   ) 
  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  12. INSPECT STEERING PAD (See  INSTALLATION   ) 
  13. PERFORM INITIALIZATION 
    1. Perform initialization (See INITIALIZATION ).

      HINT:

      Some systems need initialization when disconnecting the cable from the negative battery terminal.

  14. INSPECT SRS WARNING LIGHT 
    1. Inspect the SRS warning light (See DIAGNOSIS SYSTEM  ).
scientia non olet · About LEMON Manuals