LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2007 >> Highlander Hybrid Limited, AWD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System (Hybrid) >> Front Passenger Airbag Assembly >> Removal

Front Passenger Airbag Assembly: Removal

  1. PRECAUTION 
    CAUTION: Be sure to read "PRECAUTION" thoroughly before servicing (See PRECAUTION  ).
  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working.
  3. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY  (See REMOVAL )
  4. REMOVE INSTRUMENT PANEL NO.2 FINISH PANEL LOWER  (See REMOVAL )
  5. DISCONNECT FRONT PASSENGER AIRBAG ASSEMBLY CONNECTOR 
    1. Disconnect the connector from the front passenger airbag assembly.
      NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
      Fig 1: Disconnecting Front Passenger Airbag Assembly Connector
      G05242796Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE FRONT PASSENGER AIRBAG ASSEMBLY 
    1. Remove the bolt and the 2 nuts.
    2. Remove the front passenger airbag assembly.
      Fig 2: Identifying Front Passenger Airbag Assembly
      G05242797Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals