Engine Rear Oil Seal: Removal

REMOVE HYBRID VEHICLE TRANSAXLE ASSEMBLY
(See REMOVAL )
REMOVE TRANSMISSION INPUT DAMPER ASSEMBLY
1. Using SST, hold the crankshaft.
  SST 09213-54015 (91651-60855), 09330-00021
  
  Fig 1: Holding Crankshaft With SST
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the 6 bolts and transmission input damper from the flywheel.
  
  Fig 2: Locating Bolts And Transmission Input Damper
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FLYWHEEL SUB-ASSEMBLY
1. Using SST, hold the crankshaft.
  SST 09213-54015 (91651-60855), 09330-00021
  
  Fig 3: Holding Crankshaft
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the 8 bolts and flywheel.
  
  Fig 4: Locating Bolts And Flywheel
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE ENGINE REAR OIL SEAL
1. Using a knife, cut off the oil seal lip.
2. Using a screwdriver with the tip taped, pry out the oil seal.
  NOTE: After the removal, check that the crankshaft is not damaged. If it is damaged, smooth the surface with 400-grit sandpaper.
  
  Fig 5: Prying Out Oil Seal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002