Rear Power Point Socket: Installation
- INSTALL REAR POWER POINT SOCKET
- Assemble the rear power point socket to the rear power point socket cover at the position 10 mm (0.39 in.) away from full lock position and ensure that they are temporarily locked.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
- Place the cut-out on the trim with the claw on the rear power point socket cover and install the rear power point socket and cover to the trim.
- After installing them, fully push in the rear power point socket to install it.
- INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH (w/ Rear No. 2 Seat)
(See
INSTALLATION
)
- INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH (w/ o Rear No. 2 Seat)
(See
INSTALLATION
)
- INSTALL REAR COMBINATION LIGHT SERVICE COVER LH
- INSTALL DECK SIDE TRIM COVER LH (w/ Rear No. 2 Seat)
(See
INSTALLATION
)
- INSTALL DECK SIDE TRIM COVER LH (w/o Rear No. 2 Seat)
(See
INSTALLATION
)
- INSTALL ROPE HOOK
(See
INSTALLATION
)
- INSTALL BACK DOOR WEATHERSTRIP
- INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH
- INSTALL REAR DOOR SCUFF PLATE LH (w/ Rear No. 2 Seat)
(See
INSTALLATION
)
- INSTALL REAR DOOR SCUFF PLATE LH (w/o Rear No. 2 Seat)
(See
INSTALLATION
)
- INSTALL SEAT TRACK COVER INNER LH (w/ Rear No. 2 Seat)
- INSTALL REAR SEAT TRACK COVER LH (w/ Rear No. 2 Seat)
- INSTALL DECK SIDE TRIM BOX LH
(See
INSTALLATION
)
- INSTALL REAR SEAT RECLINING COVER NO.2 LH (w/ Rear No. 2 Seat)
(See
INSTALLATION
)
- INSTALL REAR FLOOR FINISH PLATE
(See
INSTALLATION
)
- INSTALL DECK FLOOR BOX FRONT (w/o Rear No. 2 Seat)
(See
INSTALLATION
)
- INSTALL DECK FLOOR BOX REAR
(See
INSTALLATION
)
- INSTALL DECK BOARD SUB-ASSEMBLY NO.3
- INSTALL DECK BOARD SUB-ASSEMBLY NO.2
- INSTALL DECK BOARD SUB-ASSEMBLY (w/ Rear No. 2 Seat)
(See
INSTALLATION
)
- INSTALL DECK BOARD SUB-ASSEMBLY (w/o Rear No. 2 Seat)
(See
INSTALLATION
)
- INSTALL TONNEAU COVER ASSEMBLY