LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2007 >> Highlander Hybrid Limited, AWD >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Parking Brake - Hybrid >> Parking Brake Cable >> Removal

Parking Brake Cable: Removal

  1. REMOVE REAR WHEEL 
  2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY (See  DISASSEMBLY   ) 
  3. REMOVE REAR DISC (See  DISASSEMBLY   ) 
  4. REMOVE PARKING BRAKE SHOE STRUT (See  DISASSEMBLY   ) 
  5. REMOVE PARKING BRAKE NO.1 SHOE ASSEMBLY (See  DISASSEMBLY   ) 
  6. REMOVE PARKING BRAKE SHOE ADJUSTING SCREW SET (See  DISASSEMBLY   ) 
  7. REMOVE PARKING BRAKE NO.2 SHOE ASSEMBLY (See  DISASSEMBLY   ) 
  8. SEPARATE PARKING BRAKE NO.3 CABLE ASSEMBLY 
    1. Remove the 2 bolts and separate the parking brake No.3 cable assembly from the backing plate.
      2. Fig 1: Locating Parking Brake No.3 Cable Assembly Bolts
      G05202985Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. REMOVE FUEL TANK PROTECTOR SUB-ASSEMBLY NO.1  (See REMOVAL )
  10. REMOVE PARKING BRAKE NO.3 CABLE ASSEMBLY 
    1. Remove the 2 bolts and separate the parking brake No.2 and No.3 cable assemblies from the parking brake equalizer.
    2. Remove the bolt, 4 nuts, and parking brake No.3 cable assembly.
      Fig 2: Removing Bolt, 4 Nuts, And Parking Brake No.3 Cable Assembly
      G05202986Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the parking brake cable support No.1 bracket.
scientia non olet · About LEMON Manuals