Brake Pedal: Installation

1. Install the brake pedal assembly with the 4 nuts and the bolt.

   Torque: Bolt 

   13.5 N*m (138 kgf*cm, 10 ft.*lbf) 

   Nut 

   12.7 N*m (130 kgf*cm, 9 ft.*lbf) 

2. Connect the stop light switch connector and pedal stroke switch.
   Fig 1: Locating Brake Pedal Assembly

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Apply lithium soap base glycol grease to the clevis pin.
2. Install the clevis pin and a new clip.
   Fig 2: Locating Clevis Pin And Clip

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

Refer to the installation procedures for the instrument panel safety pad sub-assembly. (See INSTALLATION )

(See DIAGNOSIS SYSTEM )

Some system need initialization when reconnecting the battery cable. (See INITIALIZATION )