Radio Receiver: Removal

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY CENTER (See REMOVAL )
REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY (w/o Navigation System)
1. Remove the 6 bolts
2. Disconnect the connector and remove the integration control and panel assembly.
  
  Fig 1: Locating Bolts And Integration Control And Panel Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY (w/ Navigation System)
1. Remove the 6 bolts.
2. Disconnect the connector and remove the integration control and panel assembly.
  
  Fig 2: Locating Bolts And Integration Control And Panel Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE RADIO RECEIVER (w/o Navigation System)
1. Remove the 6 bolts and the No.1 radio bracket.
  
  Fig 3: Locating Bolts And No.1 Radio Bracket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the 6 bolts and the No.2 radio bracket.
  
  Fig 4: Locating Bolts And No.2 Radio Bracket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE RADIO RECEIVER (w/ Navigation System)
1. Remove the 7 bolts and the multi-display controller bracket A.
  
  Fig 5: Locating Bolts And Multi-Display Controller Bracket A
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the 7 bolts and the multi-display controller bracket B.
  
  Fig 6: Locating Bolts And Multi-Display Controller Bracket B
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002