Parking Brake Cable: Removal

HINT:

For parking brake cable assembly No. 2, perform the same procedure to the parking brake cable assembly No. 3.

1. REMOVE REAR WHEEL 
2. DRAIN BRAKE FLUID 
   NOTE: Wash brake fluid off immediately if it adheres to any painted surface.
3. SEPARATE PARKING BRAKE SHOE STRUT SET LH (for TMC Made)  (See DISASSEMBLY )
4. REMOVE FRONT BRAKE SHOE (for TMC Made)  (See DISASSEMBLY )
5. REMOVE PARKING BRAKE SHOE STRUT SET LH (for TMC Made) 
6. REMOVE AUTOMATIC ADJUST LEVER LH (for TMC Made)  (See DISASSEMBLY )
7. REMOVE REAR BRAKE SHOE (for TMC Made)  (See DISASSEMBLY )
8. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY (for TMMC Made)  (See DISASSEMBLY )
9. REMOVE REAR BRAKE AUTOMATIC ADJUST LEVER LH (for TMMC Made)  (See DISASSEMBLY )
10. REMOVE FRONT BRAKE SHOE (for TMMC Made)  (See DISASSEMBLY )
11. REMOVE PARKING BRAKE SHOE STRUT SET LH (for TMMC Made) 
12. REMOVE REAR BRAKE SHOE (for TMMC Made)  (See DISASSEMBLY )
13. SEPARATE PARKING BRAKE CABLE ASSEMBLY NO. 3 
    1. Remove the bolt, and disconnect the parking brake cable assembly No. 3 from the backing plate.
       Fig 1: Identifying Parking Brake Cable

       Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
14. REMOVE EXHAUST PIPE ASSEMBLY FRONT  (See REMOVAL )
15. REMOVE FRONT FLOOR HEAT INSULATOR NO. 1 
    1. Remove the 3 nuts and front floor heat insulator No. 1.
    Fig 2: Locating Front Floor Heat Insulator No. 1 With Nuts

    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
16. REMOVE FRONT FLOOR HEAT INSULATOR NO. 2 
    1. Remove the 2 nuts and front floor heat insulator No. 2.
       Fig 3: Locating Front Floor Heat Insulator No. 2 With Nuts

       Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
17. REMOVE PARKING BRAKE CABLE ASSEMBLY NO. 1 
    1. Disconnect the parking brake cable assembly No. 1 from the equalizer and remove the parking brake cable assembly No. 1.
18. REMOVE FUEL TANK PROTECTOR NO. 1 
    1. Remove the 5 nuts and fuel tank protector No. 1.
19. REMOVE PARKING BRAKE CABLE ASSEMBLY NO. 3 
    1. Using a clip remover, disconnect the skid control sensor wire harness clip from the clamp.
    2. Remove the 4 bolts and cable retainer from the body.
    3. Disconnect the parking brake cable assembly No. 3 from the equalizer, and remove the parking brake cable assembly No. 3.
    Fig 4: Identifying Parking Brake Cable Assembly No. 3

    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002