Heater Control Assembly: Removal

REMOVE CONSOLE PANEL UPPER (See REMOVAL )
REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (See REMOVAL )
REMOVE HEATER CONTROL ASSEMBLY
1. Release the 2 fitting claws and pull out the heater control assembly.
  
  Fig 1: Identifying Fitting Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using a screwdriver, open the claw of the cable clamp and disconnect the defroster damper control cable.
  NOTE:
  - Be careful not to bend the cable wire.
  - If the cable wire bends, the heater control assembly operationally becomes worse.
  HINT:
  
  Tape the screwdriver tip before use.
  
  Fig 2: Locating Defroster Damper Control Cable
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using a screwdriver, open the claw of the cable clamp and disconnect the air mix damper control cable.
  NOTE:
  - Be careful not to bend the cable wire.
  - If the cable wire bends, the heater control assembly operationally becomes worse.
  HINT:
  
  Tape the screwdriver tip before use.
  
  Fig 3: Locating Air Mix Damper Control Cable
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Disconnect the connector, remove the heater control assembly.