Inspection Procedure

1. Remove the combination meter assy with the connectors still connected.
2. Measure the resistance according to the value(s) in the table below.
   Fig 1: Identifying Combination Meter Assy Connector Terminals

   Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

   Standard: 

   COMBINATION METER ASSY - RESISTANCE TABLE
   
   

   Tester Connection	Condition	Specified condition
   C8-12 - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard: 

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: REPLACE COMBINATION METER ASSY (SEE  OVERHAUL  )