How To Proceed With Troubleshooting

The hand-held tester can be used at step 3, 6, 9, and 12.

1. VEHICLE BROUGHT TO WORKSHOP 

   NEXT: Go to next step. 

2. CUSTOMER PROBLEM ANALYSIS CHECK  ) 

   NEXT: Go to next step. 

3. CHECK AND CLEAR DTCS AND FREEZE FRAME DATA (SEE  DTC CHECK/CLEAR   AND  FREEZE FRAME DATA OF ABS  ) 

   NEXT: Go to next step. 

4. PROBLEM SYMPTOM CONFIRMATION 

   SYMPTOM DOES NOT OCCURS: GO TO step   12 

   SYMPTOM OCCURS: GO TO STEP 6 

5. SYMPTOM SIMULATION (SEE  ELECTRONIC CIRCUIT INSPECTION PROCEDURE  ) 

   NEXT: Go to next step. 

6. DTC CHECK (SEE  DTC CHECK/CLEAR  ) 

   THERE IS NO OUTPUT: GO TO STEP 7 

   THERE IS OUTPUT: GO TO STEP 8 

7. PROBLEM SYMPTOMS TABLE  ) 

   CHECK FOR FLUID LEAKAGE AND GO TO STEP 10 

8. DIAGNOSTIC TROUBLE CODE CHART  ) 
9. CIRCUIT DESCRIPTION  

   NEXT: Go to next step. 

10. IDENTIFICATION OF PROBLEM 

    NEXT: Go to next step. 

11. REPAIR 

    NEXT: Go to next step. 

12. CONFIRMATION TEST 

    NEXT: END