Inspection Procedure
NOTE:
When replacing the ABS & TRACTION actuator assy, perform zero point calibration (see
CALIBRATION ).
- RECONFIRM DTC
HINT:
These codes are detected when a problem is determined in the ABS & TRACTION actuator assy.
The solenoid circuit is in the ABS & TRACTION actuator assy.
Therefore, solenoid circuit inspection and solenoid unit inspection cannot be performed. Be sure to check if the DTC code is output before replacing the ABS & TRACTION actuator assy.
- Clear the DTCs (see DTC CHECK/CLEAR ).
- Turn the ignition switch to the ON position.
Are the same DTCs recorded?
NG: END
HINT:
The DTCs may be memorized due to a malfunction in the connector terminal.
YES: REPLACE ABS & TRACTION ACTUATOR ASSY (SEE REPLACEMENT )