On-Vehicle Repair

WARNING: This page is about a different variant/trim than selected.

REMOVE FRONT DRIVE SHAFT (See REMOVAL )
REMOVE SIDE GEAR SHAFT OIL SEAL
Using SST, pull out the oil seal.

SST 09308-00010

Fig 1: Removing Side Gear Shaft Oil Seal
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL LH AND RH SIDE GEAR SHAFT OIL SEAL
1. Using SST and a hammer, drive in a new oil seal.
  SST 09223-00010
  
  Oil seal depth:
  
  RH: 2.0 +/- 0.5 mm (0.079 +/- 0.02 in.)
  
  LH: 5.9 +/- 0.5 mm (0.232 +/- 0.02 in.)
2. Coat the lip of the oil seal with MP grease.
INSTALL FRONT DRIVE SHAFT (See INSTALLATION )
CHECK ATF LEVEL (See PRE-CHECK )

Fig 2: Installing Front Drive Shaft
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002