LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2005 >> ECHO 2D Sedan, Standard >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brakes - Mechanical >> Rear Speed Sensor >> Installation

Rear Speed Sensor: Installation

  1. INSTALL NEW ABS SPEED SENSOR 
    1. Clean the contacting surface of the axle hub and a new ABS speed sensor.
      NOTE: Do not stick any foreign objects to the sensor rotor.
    2. Place the ABS speed sensor on the axle hub so that the connector is set at the bottom under the on-vehicle condition.
      Fig 1: Identifying ABS Speed Sensor
      G02575625Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Using SST and a press, install a new ABS speed sensor to the axle hub.

    SST 09214-76011

    NOTE:
    • Do not tap the speed sensor with a hammer directly.
    • Check that there should be no foreign objects on the speed sensor detection portion.
    • Press in the ABS speed sensor straight and slowly.
    Fig 2: Installing ABS Speed Sensor To Axle Hub Using SST
    G02575626Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL SPEED SENSOR WITH REAR AXLE HUB (See  INSTALLATION  ) 
  3. CONNECT SPEED SENSOR CONNECTOR 
  4. INSTALL REAR WHEEL 

    Torque: 103 N.m (1,050 kgf.cm, 76 ft.lbf) 

  5. CHECK SPEED SENSOR SIGNAL (See  PRE-CHECK  ) 
scientia non olet · About LEMON Manuals