LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2005 >> Camry Base, Automatic >> Repair and Diagnosis >> Brakes >> Anti-Lock Brakes >> Brakes - Abs With EBD (DENSO Made) - Diagnostics >> TS Terminal Circuit >> Inspection Procedure

Inspection Procedure

  1. INSPECT DLC3(TS TERMINAL) 
    1. Turn the ignition switch to the ON position.
    2. Measure the voltage according to the value(s) in the table below.

      Standard: 

      TESTER CONNECTION SPECIFIED CONDITION (1 OF 2)

      Tester Connection Condition Specified Condition
      D3-12 (TS) - D3-4 (CG) IG switch ON 10 to 14 V
      Fig 1: Inspecting DLC3 (TS Terminal)
      G02633614Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. NG: Go to step   3 

    OK: Go to Next Step. 

  2. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - DLC3) 
    1. Check the harness and connector between the skid control ECU and DLC3.
    1. NG: REPAIR OR REPLACE HARNESS OR CONNECTOR (TS CIRCUIT) 

    OK: CHECK AND REPLACE BRAKE ACTUATOR ASSY (SEE  REPLACEMENT  ) 

  3. CHECK HARNESS AND CONNECTOR(DLC3 - BODY GROUND) 
    1. Measure the resistance according to the value(s) in the table below.

      Standard: 

      TESTER CONNECTION SPECIFIED CONDITION (2 OF 2)

      Tester Connection Specified Condition
      D3-4 (CG) - Body ground Below 1 Q
      Fig 2: Checking Harness And Connector (DLC3 - Body Ground)
      G02633615Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. NG: REPAIR OR REPLACE HARNESS OR CONNECTOR (GND CIRCUIT) 

    OK: Go to Next Step. 

  4. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - DLC3) 
    1. Check the harness and connector between the skid control ECU and DLC3.
    1. NG: REPAIR OR REPLACE HARNESS OR CONNECTOR (TC CIRCUIT) 

    OK: CHECK AND REPLACE BRAKE ACTUATOR ASSY (SEE  REPLACEMENT  ) 

scientia non olet · About LEMON Manuals