Inspection Procedure

HINT:

This code is detected when a problem is determined in the brake actuator assy.

The solenoid circuit is in the brake actuator assy.

Therefore, solenoid circuit inspection and solenoid unit inspection cannot be performed. Be sure to check if the DTC code is output before replacing the brake actuator assy.

1. Clear the DTCs (See PRE-CHECK  ).
2. Turn the ignition switch to the ON position.
3. Are the same DTCs recorded? (See PRE-CHECK  ).

1. NO: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (See  PROBLEM SYMPTOMS TABLE   ) 

YES: REPLACE BRAKE ACTUATOR ASSY (See  REPLACEMENT  )