Inspection Procedure

RECONFIRM DTC (SEE DTC CHECK/CLEAR )

HINT:

These codes are detected when a problem is identified in the brake actuator assy.

The solenoid circuit is in the brake actuator assy.

Therefore, solenoid circuit inspection and solenoid unit inspection cannot be performed. Be sure to check if the DTC is output before replacing the brake actuator assy.

Clear the DTC.
Start the engine.
Drive the vehicle at the speed of 12 mph (20 km/h) or more for 30 seconds or more.

Check that the same DTC is recorded.

Result:

RECONFIRM DTC

DTC is not output	A
DTC is output	B

HINT:

If the normal system code is output (the malfunction code is not output), slightly jiggle the connectors, wire harnesses, and fuses of the brake actuator assy. Make sure that no DTCs are output.
If any DTCs are output while jiggling a connector or wire harness of the brake actuator (skid control ECU), inspect and repair the connector or wire harness.

B: REPLACE BRAKE ACTUATOR ASSY (SEE REPLACEMENT )
A: END

HINT:

It is suspected that the DTCs were output due to a bad connection of the connector terminal.