Inspection Procedure

WARNING: This page is about a different car, the 2006 Toyota Tundra and 2005 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: When replacing the master cylinder solenoid, perform zero point CALIBRATION .

Check DTC (See DTC CHECK / CLEAR ).
CHECK:

Check DTCs.

RESULT:
DTC OUTPUT RESULT

DTC is not output A

DTC is output B
1. B : Repair circuit according to the output code (See DIAGNOSTIC TROUBLE CODE CHART ).
2. A : Go to next step.
Check battery voltage.
CHECK:

Check the battery voltage.

OK:

11 to 14 V
1. NG : Check and repair CHARGING SYSTEM : 1GR-FE or CHARGING SYSTEM : 2UZ-FE.
2. OK : Go to next step.
Check for open or short circuit in harness and connector between master cylinder solenoid (skid control ECU) and combination meter.
1. NG : Repair or replace harness or connector.
2. OK : Go to next step.
Inspect combination meter (See CIRCUIT ).
CHECK:

Check combination meter.

OK:

Combination meter is normal.
1. NG : Check and repair combination meter.
2. OK : Replace master cylinder solenoid (See DISASSEMBLY ).

DTC is not output	A
DTC is output	B