Monitor Status: Notes

The Monitor Status (mode 6) allows the OBD scan tool to display the monitor result, test value and test limit (malfunction criterion). A problem in the EVAP system can be found by comparing the test value and test limit. This procedure is described in "CHECKING MONITOR STATUS" (see CHECKING MONITOR STATUS ). Check the monitor status after running the vehicle with the monitor drive pattern (Refer to MONITOR CONFIRMATION DRIVE PATTERN ).

• TID (Test Identification) is assigned to each emission-related component.
• TLT (Test Limit Type):

  If TLT is 0, the component is malfunctioning when the test value is higher than the test limit.

  If TLT is 1, the component is malfunctioning when the test value is lower than the test limit.

• CID (Component Identification) is assigned to each test value.
• Unit Conversion is used to calculate the test value indicated on generic OBD scan tools.