Inspection Procedure

WARNING: This page is about a different variant/trim than selected.

HINT:

DTC P2610 is set if an internal ECM problem is detected. There are not diagnostics required. ECM replacement is required.

REPLACE ECM (See REPLACEMENT )
1. NEXT: GO TO NEXT STEP.
CONFIRM DTC (AFTER REPAIR)
1. Connect the hand-held tester to the DLC3.
2. Turn the ignition switch ON.
3. Clear the DTC with the hand-held tester.
4. Start the engine and wait 10 minutes or more.
5. Confirm the pending DTC. Enter the following menus: DIAGNOSIS/ENHANCED OBDII/DTC INFO/PENDING DTC.
6. If no DTC is displayed, the repair has been completed properly.