Inspection Procedure

WARNING: This page is about a different variant/trim than selected.

HINT:

Read freeze frame data using the hand-held tester or the OBD II scan tool. Freeze frame data records the engine conditions when a malfunction is detected. When troubleshooting, freeze frame data can help determine if the vehicle was running or stopped, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.

CHECK OTHER PTC OUTPUT (IN ADDITION TO PTC P2119)

DTC OUTPUT RESULT

Display (DTC output)	Proceed to
Only P2119 is output	A
P2119 and other codes are output	B

B: GO TO RELEVANT DTC CHART (See DIAGNOSTIC TROUBLE CODE CHART )
A: GO TO NEXT STEP.

CHECK IF DTC OUTPUT REOCCURS
1. Clear the DTC (see DTC CHECK/CLEAR ).
2. Allow the engine to idle for 15 seconds.
3. Pull the hand brake and shift the gear to D.
4. Depress the brake pedal securely and the accelerator pedal fully for 5 seconds.
5. Read the DTC.
  HINT:
  
  Actual throttle position (TP) sensor voltage can be confirmed using the hand-held tester [DATA LIST/ALL /THROTTLE POS #1].
  
  OK: No DTC is output.
1. OK: NORMAL
2. NG: REPLACE THROTTLE BODY ASSY